Keep your Engine Happy
Our readers are constantly coming up with great ways to maximize their enjoyment of the RC hobby. Whether it is a simpler way to solve a recurring problem, or a better way to save some cash, our Shop Tips mailbag is always full. Here are a few tips for keeping your RC engine happy.
Gasoline engines usually are very user-friendly. If however your engine starts to act up, becomes more difficult to start or won’t transition smoothly from idle to full power, chances are the internal fuel filter in the Walbro pumper carb is dirty or clogged. To get to it, remove the side cover on the carb that has a single screw in the center, remove the screw and carefully remove the cover without damaging the gasket. Use fresh fuel to flush away debris or if the screen is badly clogged, go to a small engine shop and buy a carburator rebuild kit and replace the inlet filter screen. Now is a good time to check the condition of the gaskets and replace any questionable ones. Replace the cover and screw it into place and you’re good to go!
Walter Watkins, Aiken SC
Heat Treatment for Engines
Do you have an engine that has been stored away and has been out of service for a while? How do you get it back in service when you find it is locked up tight? Well, there is a quick and easy solution to free up the engine. Place the engine in a 200 oven for about 10 to 15 minutes. Then, using a dish towel or an oven mitt, turn the engine over. 99% of the time the oven heat will break the engine internals free so it can be turned over. Take the engine out of the oven, and load the engine down the intake and through the exhaust with some penetrating oil such as Marvel Mystery Oil or 3-In-One. Flip the prop a few more times and the engine will be nice and free ready for use. Just be sure to back the needle valve out four or five turns the first time you run it so that it starts up slobbering rich, then let it run that way for a few minutes to give any stuck ball bearing balls, etc., a chance to free up.
Lee, Clarence . "Keep your Engine Happy." Model Airplane News. 04 17 2012: n. page. Web. 17 Jun. 2013. http://www.modelairplanenews.com/blog/2012/04/17/workshop-tips-keep-your-engines-happy